beautypg.com

Operating instructions (continued) – Empire Comfort Systems DVP42FP7 EN User Manual

Page 30

background image

Page 30

17375-6-0705

STANDING PILOT OPERATING INSTRUCTIONS

REMOTE/OFF/ON Switch

The fireplace is equipped with a REMOTE/OFF/ON switch. A

wire harness is attached to the REMOTE/OFF/ON switch. The

red, black and green (wires) female push-ons attach to the RE-

MOTE/OFF/ON switch. At the opposite end of the wire harness,

the black and green (wires) female push-ons attach to the gas valve.

An additional green wire and the red wire, which are stripped and

bare, will attach to one of the accessories that can be purchased

for use with your fireplace.
Operation of REMOTE/OFF/ON Switch with no

Accessories

To ignite main burner, turn the control knob on the gas valve

from the PILOT position to the ON position. Turn the REMOTE/

OFF/ON switch from the OFF position to the ON position. The

additional green wire and red wire, which are stripped and bare

are not used.
Wall Switch, FWS-1

Connect the green and red, stripped and bare, wires on the

REMOTE/OFF/ON switch wire harness to the wall switch. Turn

the REMOTE/OFF/ON switch to the REMOTE position. Pivot

the rocker switch on the FWS-1 to the ON position.
Wall Thermostats (optional)
TRW - Wireless for Millivolt models

TMV - Reed switch for Millivolt models
Battery Operated Remote Controls, FRBC, FBRTC, and

TRW

Connect the green and red, stripped and bare, wires on the

REMOTE/OFF/ON switch wire harness to the remote receiver

that is a component in the remote kit. Turn the REMOTE/OFF/ON

switch to the REMOTE position. Follow instructions included

with the remote to complete installation.

Note: If batteries fail in the remote, and immediate heat is desired,

turn the REMOTE/OFF/ON switch from the REMOTE position

to the ON position.
Electric (120 volt) Operated Remote Control, FREC
Connect the green and red, stripped and bare, wires on the

REMOTE/OFF/ON switch wire harness to the wires on remote

receiver that is a component in the FREC. Turn the REMOTE/

OFF/ON switch to the REMOTE position. Follow instructions in

the FREC to complete installation.
NOTE: If electric (120 colt) fails in FREC, and immediate heat is

desired, turn the REMOTE/OFF/ON switch from the REMOTE

position to the ON position.

Installation of Remote Receiver

Place remote receiver on the floor of fireplace behind the louver

as far forward as possible.
Attention: The velcro loop and hook are not necessary in this

installation but can be used to secure remote receiver.
Refer to remote control installation and operating instructions for

more details on remote control.
Millivolt Control

The valve regulator controls the burner pressure which should be

checked at the pressure test point. Turn captured screw counter

clockwise 2 or 3 turns and then place tubing to pressure gauge

over test point (Use test point “A” closest to control knob). After

taking pressure reading, be sure and turn captured screw clockwise

firmly to re-seal. Do not over torque. Check for gas leaks.
Millivolt thermopile is self generating. Gas valve does not require

24 volts or 110 volts.
Check System Operation

Millivolt system and all individual components may be checked

with a millivolt meter 0-1000 MV range.

It is important to use wire of a gauge proper for the length of the

wire:

Recommended Wire Gauges

Maximum Length

Wire Gauge

1' to 10'

18

10' to 25'

16

25' to 35'

14

OPERATING INSTRUCTIONS (continued)

This manual is related to the following products: