Casio EA-100 Commands and Programming - Manual (Page 31)

53
Chapter 3: Commands and Programming
0 Raw data
Filtered data is returned when data filtering is turned on with the
filter parameter of Command 3.
1 d/dt
Filtered data when data filtering is on.
2 d 2 /dt 2
Filtered data when data filtering is on.
3 Raw data
Filter setting is ignored.
4 d/dt
Filter setting is ignored.
5 d 2 /dt 2
Filter setting is ignored.
Specifying 3, 4, or 5 for this parameter makes it possible to transfer unfiltered
data even when filtering is specified by the filter parameter of Command 3.
All subsequent Receive( commands transfer unfiltered data until this data
select parameter is change to 0, 1, or 2.
In the same way, specifying 0, 1, or 2 for this parameter causes subsequent
Receive( commands to transfer filtered data to the calculator.
• To transfer d/dt , d 2 /dt 2 , or statistical data, you must use the post-process-
ing parameter of Command 1 to specify the type of post-processing to
be performed.
Data Begin Parameter
This parameter specifies the starting sample number for data being sent to a
CFX-9850G list or matrix. The initial default for this parameter is 1.
1 to 512 Starting sample number
Data End Parameter
This parameter specifies the ending sample number for data being sent to a
CFX-9850G list or matrix. The initial default for this parameter is 0.
The value specified for this parameter must be greater than or equal to the
specification made for the data start parameter. Specifying a value of 0 here
causes the data end parameter to be ignored, transferring all data up to the
final sample.
0 to 512 Ending sample number
• When transferring data to the CFX-9850G, the data range must be set
so the total number of data items is 255 or less.