Casio EA-100 Commands and Programming - Manual (Page 3)

25
Chapter 3: Commands and Programming
Number Description
6 MULTIMETER MODE SETUP
This command sets the Multimeter Mode unit of measurement
for a particular channel.
7 REQUEST STATUS
This command creates a data list concerning the data
analyzer’s current status (error status, probe connection data,
etc.) being requested by the connected calculator.
8 SAMPLING START
This command causes the data analyzer to start sampling im-
mediately.
9 PROBE CALIBRATE
This command calibrates probe sampling values and is used
to calibrate sampling levels when multiple probes are being
used.
Initial Settings
The standard syntax for a command is {1,n,n,n,n,...}, where “n” indicates a
parameter. Command parameters are automatically set to their initial de-
faults whenever any of the following occurs.
• When a parameter is not specified inside a command.
• Whenever an Auto-ID operation is performed.
• Whenever the data analyzer is put into the READY state by operation of
the [RESTART] key.
• Whenever you exit the Setup Mode after changing settings, and the data
analyzer enters the READY state.
You can find information about the initial defaults for each command in the
Command Reference.
P.36