Casio EA-100 Commands and Programming - Manual (Page 16)

38
Chapter 3: Commands and Programming
1 Auto-ID
If Auto-ID is not activated, voltage in the range 0 to 5V is used.
2 Voltage (
±
10V)
3 Current (
±
10A)
Based on Vin input, 1V = 1A.
4 Resistance (1k
Ω
to 100k
Ω
)
5 Period (0.000004 to 50 seconds)
See “Period and Frequency Measurement” in Appendix A.
6 Frequency (0.02Hz to 250kHz)
See “Period and Frequency Measurement” in Appendix A.
7 Temperature (–20
°
C to 130
°
C)
8 Temperature (–4
°
F to 266
°
F)
9 Light (100 to 999)
10 Voltage (0 to 5V)
Post-Processing Parameter
This parameter specifies the type of post-processing to be applied to sam-
pled data. The initial default for this parameter is 0.
0 None (no processing)
1 d/dt (first derivative)
Only the d/dt indicator is on the display when this type of post-
processing is selected.
2 d/dt and d 2 /dt 2 (first derivative and second derivative)
The d/dt and d 2 /dt 2 indicators are on the display when this type
of post-processing is selected.
3 Statistics (mean, standard deviation, minimum, maximum)
Derivative and statistical post-processing are performed using values pro-
duced by conversion equations.
• Post-processing is disabled whenever the number of samples parameter
of Command 3 (SAMPLING/TRIGGER SETUP) is –1, which specifies
real-time display of sampled data.
Stat Samples Parameter
This parameter is used during statistical post-processing to specify how many
samples should be used for post-processing. This parameter is valid only
when 3 (statistics) is specified for the post-processing parameter. A value
from 2 to 512 can be specified for this parameter, and The initial default for
this parameter is 10.
P.68
P.68