beautypg.com

Chap 2-using the equity ii, Safety rules, Powering up – Epson Equity II User Manual

Page 28: Using the equity ii, Chapter 2

background image

Chapter 2

Using the Equity II

After you set up your system, you’re ready to turn on the power and

start using your computer. But before you turn it on, read the following

safety rules.

Safety Rules

Follow these rules to avoid accidentally damaging your computer or

injuring yourself:

Never turn the computer on or off with a disk protector sheet in a

disk drive.

Do not attempt to dismantle any part of the computer. Only remove

the top cover to install and remove option cards. If you cannot solve

a hardware problem after you read Chapter 5 on troubleshooting, or

if you want to install the optional 8087 math coprocessor, consult

your Epson dealer.

Always turn off the power, disconnect the computer’s power cord,

and wait a few minutes before you remove the computer’s cover.

Do not unplug cables from the computer when the power is on.

Never turn off the computer while the red LED lamp on a disk drive

is on. This can destroy data stored on disk or make a whole disk

unusable.

Always wait at least 5 seconds after you switch off the power before

you switch it on again. Turning the power off and on rapidly can

damage the computer’s circuitry.

Do not leave a beverage on top of or near your system or any of its

components. Spilled liquid can damage the circuitry of your compo-

nents.

Powering Up

Before you turn on your system, be sure you plugged the power cord

into the AC input on the back panel of the main unit. Then plug the

power cord into a 3-prong, 120-volt, grounded electrical outlet.

21