Enterasys Networks 6H2xx - Manual (Page 338)

Built-in Commands
12-4 Network Tools Screens
The commands are presented in the following format:
12.2 BUILT-IN COMMANDS
The built-in commands listed in this section activate functions on the LM managed device or
devices being accessed through Network Tools.
command
Description: Briefly describes the command and its uses.
Syntax: Shows the required command format. It indicates where arguments, if any,
must be specified.
Options: Lists any additional fields in the appropriate format that may be added to the
command.
Example: Shows an example of the command.
alias
Description: Used to enable and disable snooping (per Port). Also clears retrieval and
clearing of stats along with listing and setting of various configuration items.
Syntax: alias [enable | disable | status] [ALL | port # | port range, i.e., 1-5]
alias [stats]
alias [clear_stats]
alias [fwd_list]
alias [fwd_set] [rate | burst] [value]
Options: enable – Enables alias snooping on specific port or port range.
disable – Disables alias snooping on specified ports or port range
status – Displays the current alias snooping state (enabled or disabled) on a
port or port range.
stats – Displays current alias snooping state statistics.
clear_stats – Clears all alias snooping statistics.
fwd_list – Lists current configuration settings including max frame size, max
host queue, max PPS, and max burst.
fwd_set – Allows setting of max PPS and/or max burst configuration settings.