Soft_reset, Stpedgeport – Enterasys Networks 6H2xx User Manual
Page 362
Built-in Commands
12-28
Network Tools Screens
soft_reset
Description:
Restarts the software image, which restores the user configuration settings
from NVRAM. The user will be queried to confirm the reset command to
ensure against unwanted resets.
TIP: The Network Tools connection to the device will be terminated
upon execution of this command.
Syntax:
soft_reset
Options:
None
Example:
->soft_reset
RESET: Are you *SURE* ?
-> Y
stpEdgePort
Description:
Sets a port to EDGE PORT (enable) or BRIDGE PORT (disable).
Syntax:
stpEdgePort [ status ]
stpEdgePort [ enable ] [ vlan id ] [ port range ]
stpEdgePort [ disable ] [ vlan id ] [ port range ]
Options:
stpEdgePort enable
stpEdgePort disable
stpEdgePort status
Example:
To enable EdgePort on VLAN 1, port 5:
-> stpEdgePort enable 1 5
To enable EdgePort on VLAN ports 5-10:
-> stpEdgePort enable 1 5-10