Mac_lock trap enable – Enterasys Networks 6H2xx User Manual
Page 351
Built-in Commands
Network Tools Screens
12-17
MAC_lock trap enable
Description:
Enables the sending of MAC violation traps by either individual port or on all
ports of the module.
If the MAC lock trap is enabled on a port, the switch sends a trap when the
port receives a frame containing a source MAC address that is different from
the currently locked MAC address. This trap is sent only once. It is not sent
again until the trap has been reset by a link-state change, trap disable/enable
toggle, MAC authentication/unauthentication, or MAC locking
enable/disable. Traffic is not stopped when a violation occurs. Frames with
source MACs different from the currently “locked” MAC are discarded.
Syntax:
MAC_lock trap enable [ port# | all ]
Options:
port# – Number of the port that will have MAC lock trap enabled.
all – Enables MAC locking on all ports of the module.
Example:
-> MAC_lock trap enable 3
-> MAC_lock trap enable all