Magnum Energy MM-R Remote - Manual (Page 5)

©
2010 Magnum Energy, Inc.
1.0 Introduction
Congratulations on your purchase of the MM-R and/or MM-RC
remote controls from Magnum Energy, Inc. These remotes are de-
signed to be simple to install and use, and enable easy control and
quick indication of the inverter’s (and charger’s) status.
Remotes Available
The MM-R and the MM-RC are the two remote controls available for
use with the MM/MM-AE Series inverter. The appropriate remote to
use depends on whether your inverter includes the battery charger
feature. For the MM Series inverter that does not have the battery
charger, the MM-R is the recommended remote; for MM/MM-AE
Series inverters that do have the battery charger, the MM-RC is
recommended.
The MM-R and MM-RC remotes offer the following features:
MM-R - Provides three LED indicators for inverter status, and
includes a remote ON/OFF switch. The unit comes with 25’ cable.
This remote is for the MM612 model (requires serial number L1-
201 or higher).
MM-RC - Provides six LED indicators for inverter and charger sta-
tus, and includes a remote ON/OFF switch. The unit comes with 25’
cable. This remote is for the MM1212, MM612AE, MM1512AE, and
MM1524AE models.
Figure 1, MM-R and MM-RC Remote Controls
M M -R M M -R C
B U L K
A B S O R B
FA U L T FL O A T
A C IN
IN V E R T
O N / O FF
IN V E R T
A C IN
FA U L T
O N /O FF
1.0 Introduction
Basic Features
• Colored LED’s (Light Emitting Diodes) located on the front panel
for easy viewing of system status.
• A RJ11 phone jack connection for easy connection to inverter.
• Status and information indicators used to determine system per-
formance and operating conditions, including: inverter operation,
charger operation and any faults that occur.
• ON/OFF push button for easy control of inverter and charger
operation.
• Easy installation – can be fl ush mounted (in the wall) or use
the included mounting ring to give installers the option of surface
mounting (on the wall).
1