LinPlug RMV - Manual (Page 46)

Audio Modules
Ride Cymb. (Cymbal)
The Ride Cymb. (Cymbal) module combines a pitched oscillator and a noise oscillator.
The Ride Cymb. (Cymbal) Percussion Synthesis module contains the following controls:
Osc(illator) Freq(uency): The setting of the Osc(illator) Freq(uency) control determines
the sound's fundamental frequency. The frequency changes from low
to high as the dial is turned in a clockwise direction. Note that this
control interacts with the Tune control on the associated Pad.
Osc(illator) Harmonic: The Osc(illator) Harmonic control is used to set the harmonic
content of the oscillator. In general, as the control is turned
clockwise, the sound becomes brighter.
Osc(illator) Decay (Time): The Oscillator Decay (Time) control determines the rate at
which the pitched part of the cymbal sound decays. Turning the
control in a clockwise direction increases the pitched oscillator decay
time.
Noise Colour: The Noise Colour control is used to set the frequency spectrum of
the noise oscillator.
Noise Decay (Time): The Noise Decay (Time) control is used to set the rate at which the
noise part of the cymbal sound decays. Turning the control in a
clockwise direction increases the noise oscillator decay time.
Modulation Freq(uency): The Modulation Freq(uency) control is used to set the
LinPlug Reference Manual 5.0.1 46