LinPlug RMV - Manual (Page 39)

Audio Modules
Noise Colour: The Noise Colour control setting determines the frequency spectrum
of the noise generator.
Noise Reso(nance): The Noise Res(onance) control is used to set the amount of
emphasis around the noise oscillator's cutoff frequency. Higher
settings create a more pronounced peak in the signal while lower
settings produce a flatter response.
Noise Decay (Time): The Noise Decay (Time) control sets the decay time of the noise
component of the drum sound.
Noise Env(elope) Mod(ulation): The Noise Env(elope) Mod(ulation) control is used to
set the degree to which the noise oscillator's filter cutoff frequency is
modulated by the oscillator's amplitude envelope
.
Noise HPF (High Pass Filter): The Noise HPF (High Pass Filter) control is used to set
the cutoff frequency of a high pass filter that processes the output of
the noise oscillator. Rotating the control in a clockwise direction
increases the cutoff frequency of the filter.
Mix: The Mix control is used to set the relative amounts of the pitched
oscillator and the noise oscillator in the output signal. Rotating the
control in the anti-clockwise direction increases the proportion of
pitched oscillator signal in the output, while rotating the control in the
clockwise direction increases the proportion of noise signal in the
output.
LinPlug Reference Manual 5.0.1 39