LinPlug RMV - Manual (Page 17)

Controls
Controls
Users have the option of controlling all dials in either a circular or a linear manner
depending on the Dial Mode setting on the RMV's Setup Panel (see the "Setup Panel"
section of this manual for more information).
Holding down the ALT key while clicking on a control changes the selected control's value
a minimum step upwards (when clicking in the upper half of the control) or a minimum step
downwards (when clicking in the lower half of the control). The value of the minimum step
varies depending upon the control.
Holding down the CTRL key while clicking on a control sets the control to its default value
(e.g. for Volume controls it sets the control's value to -3 dB). The value of the default
setting varies depending upon the control.
Holding down the SHIFT key while changing a control's value enables finer control values
to be set.
When controls are changed, the value of the control is displayed in the corresponding
active Pad's Data Display. After a short period of time the Data Display reverts to showing
the title of the respective Pad. This applies to all RMV pad controls except those found in
the Audio Modules and the Modulation Matrix.
All controls can be automated and controlled using external MIDI messages. To use
external devices it is necessary to use the RMV's ECS which is described in detail later in
this manual.
PC users who have a mouse with a wheel can use the mouse-wheel to change RMV
parameter values provided that the host software supports this (an example of a VST host
program that supports the use of mouse-wheels is Cubase).
LinPlug Reference Manual 5.0.1 17