Bang & Olufsen BeoVision 8-26/32 - Manual (Page 22)

22
Set up your television
For information about how to fasten
and run the cables on the rear of the
television, refer to this page.
For further information about the
socket panel, refer to page 2.
Avoid placing your television in direct sunlight
or direct artificial light, such as a spotlight, as
this may reduce the sensitivity of the remote
control receiver. Also if the screen is overheated,
black spots may appear in the picture. These
spots disappear again, once the television
cools down to normal temperature.
To avoid injury, use Bang & Olufsen approved
stands or wall brackets only.
Make sure that the television is set up, placed
and connected in accordance with these
instructions.
The television is developed for indoor use in
dry, domestic environments only. Use within
a temperature range of 10–40°C (50–105°F).
Do not place any items on top of the television.
Always place your television on a firm and
stable surface.
Do not attempt to open the television. Leave
such operations to qualified service personnel.
Your television was designed to be left in
standby mode when not in use. Therefore, to
facilitate remote control operation, it is
essential that you do not disconnect it from
the mains. The television can only be switched
off completely, if you disconnect it from the
mains.
To remove the cover for the connection panel, first
pull out, then pull down at the bottom, also if the
television is placed on a video stand.
IMPORTANT! For safety reasons the mains supply
cable must be fastened to the cable strip (A). All
cables must be run through the cable strip (B).
However, if your setup includes a VGA connection,
do not run the VGA cable through the cable strip
(B). Instead, use the two screws in the VGA plug
to fasten it to the socket.
Handling your television
A
B