Bang & Olufsen BeoVision 11 with Beo4 User Guide (No tuner) - Manual (Page 13)

13
>> Set up additional equipment
Unconfigure a source
If you have connected and configured a
source to a specific socket on the television
and then disconnect the source permanently,
you must reset the source settings. Highlight
the source in the SOURCE LIST menu, press
the red button and select RESET TO
DEFAULT. When you select YES, the source
is no longer configured to this socket. Next
time you connect a source to the socket, you
are asked to configure the source.
You can also select RESET TO DEFAULT in the
ADVANCED SETTINGS menu to reset to
default values only for this menu.
To remove the downloaded PUC table, see
page 33 .