Bang & Olufsen BeoVision 11 with Beo4 User Guide (No tuner) - Manual (Page 11)

11
During setup of a source via the SOURCE
LIST SETUP menu you can select how a
PUC controlled product is connected.
You can choose between PLUG (cable)
and IR BLASTER (IR-transmitter). If you
select PLUG, you must choose between
MODULATION ON and MODULATION
OFF. For information about type of cable
and modulation settings, contact your
Bang & Olufsen retailer.
IR-transmitters: To operate non-Bang &
Olufsen products with a Beo4/Beo6 remote
control, attach a Bang & Olufsen IR-
transmitter on your non-Bang & Olufsen
product and then connect it to one of the
sockets marked PUC on the connection
panel. Attach the transmitter near the IR-
receiver on the connected equipment to
ensure remote control operation. Before
attaching it, check that you can operate the
equipment menus on the television screen
using the Beo4/Beo6 remote control.
For an extra PUC cable, contact your Bang &
Olufsen retailer.
For information about download of
Peripheral Unit Controller (PUC) tables for
set-top boxes,
see page 33 .
>> Connections
Control
STB
STB
PLUG
IR