Epson BALUNS FG01281 - Manual (Page 22)

22 Using the Document Camera
Turning On Your Equipment
Make sure your document camera and other equipment are set up and
connected correctly, as described in Chapter 1. Always turn on your
projector or monitor first. Then turn on your document camera, as
described below, followed by any other equipment you’ve connected
to it.
If you have one or two computers connected to the document
camera’s
RGB INPUT ports, you may have to switch between sources
to see the desired image. See page 24 for details.
Turning On the Document Camera
Follow these steps to plug in and turn on the document camera:
1. Connect one end of the power cord to the document camera’s
power inlet.
2. Connect the other end to a grounded electrical outlet.
3. Turn on the projector or monitor.
4. Turn on the document camera. After a moment, the upper lamps
turn on.
Power inlet
On/Off
switch