Lanner RS12-38800 User Manual
Page 45
RS12-38800
45
configuration. Select [Disabled] in ATA/IDE Configuration if you want to disable
both ATA/IDE configuration. Select [Compatible] or [Enhanced] to use the IDE,
S-ATA and PATA devices. Refer to the following tables for details.
Primary, Third and Fourth IDE Master/Slave
While entering Setup, the BIOS automatically detects the presence of IDE devices.
There is a separate sub-menu for each IDE device. Select a device item then press
The BIOS automatically detects the values opposite the dimmed items
(Device, Vendor, Size, LBA Mode, Block Mode, PIO Mode, Async DMA, Ultra
DMA, and SMART monitoring). These values are not user-configurable.
These items show N/A if no IDE device is installed in the system.
Hard disk boot priority: Select boot sequence for onboard (or add-on cards) SCSI,
RAID, etc.
Type: Selects the type of IDE drive. Setting to Auto allows automatic selection of
the appropriate IDE device type. Select CDROM if you are specifically configuring a
CD-ROM drive. Select ARMD (ATAPI Removable Media Device)
If your device is either a ZIP, LS-120, or MO drives.
Configuration options: [Not Installed] [Auto] [CDROM] [ARMD]
LBA/Large Mode: Enables or disables the LBA mode. Setting to Auto enables the
LBA mode if the device supports this mode, and if the device was not previously
formatted with LBA mode disabled.