Chapter 1, Introduction, Front panel features – Lanner FW-8893C User Manual

Page 8

Introduction

Chapter 1

Network Application Platforms

F1 Power/Status/HDD LED

Power: If the LED is on it indicates that the system is powered on. If it is off, it indicates that the system is powered off.
Status: This LED is programmable. You could program it to display the operating status with the behavior like:
If the LED is green, it indicates that the system’s operational state is normal. If it is red, it indicates that the system is

malfunctioning.
HDD: If the LED blinks, it indicates data access activities; otherwise, it remains off.

F2 System Panel with keypad: LCD System Panel

The LCD System Panel can be programmed to display operating status and configuration information. For more details

or sample programming code, please refer to the Drivers and User’s manual CD.

F3 Console Port

By using suitable rollover cable or RJ-45 to DB-9 Female (Cisco console cable), you can connect to a computer terminal

for diagnostic or configuration purpose. Terminal Configuration Parameters: 115200 baud, 8 data bits, no parity, 1 stop

bit , no flow control.

F4 Two USB 2.0 Ports

It connects to any USB devices, for example, a flash drive.

F5 Management Port (LAN1 and LAN2 which are provided by Intel 82574L)

This FastEthernet port can be connected for configuration or troubleshooting purpose. Conformity with IPMI (Intelligent

Platform Management Interface) can be implemented through OPMA on LAN1. LAN2 is also capable of Preboot eXecution

Environment (PXE) to boot computers using a network interface. (This feature can be enabled or disable in the BIOS; the

default is disabled).

Front Panel Features

Bypassed ports

LAN1 LAN3 LAN5 LAN7 LAN9 LAN11 LAN13

LAN2 LAN4 LAN6 LAN8 LAN10 LAN12 LAN14

FW-8893

FW-8893C

LAN2 LAN4 LAN6 LAN8 LAN10