Lanner FW-8893C - Manual (Page 13)

8
Introduction
Chapter 2
Network Application Platforms
Hard Disk Installation
The system support one 2.5” internal HDD installation.
Follow these steps to install a HDD:
Unsrew the 4 screws on the hard disk tray to take out 1.
the hard disk tray from the system.
Place hard disk on the hard disk tray and align the
2.
holes on the hard disk with the mounting holes on
the tray.
Secure the hard disk with 4 mounting screws on the
3.
hard disk tray.
Connect the Serial-ATA power and data cables to the
4.
hard disk’s power and data connectors respectively.
Fix the hard disk back to the system with the screws.
5.
Plug the Serial-ATA cable to the Serial-ATA Connector 6.
on the main board.
Note:
If you have only one CPU, install it on the left 1.
side (CPU socket No.1with the front panel
facing you). Failure to do so will result in boot
failure. Note that the two ports farthest to
the right will be disabled if only one CPU is
installed.
To protect the CPU socket pins, retain the CPU 2.
cap when the CPU is not installed.
6