Ericsson LBI-39076B - Manual (Page 8)

LBI-39076B REGULATORY COMPLIANCE
8
REGULATORY COMPLIANCE (Cont.)
FEDERAL COMMUNICATIONS COMMISSION (FCC) REGULATIONS
b. Incoming call is routed to a dial prompt.
c. Incoming call is routed to a recorded announcement that can be administered by the CPE (Customer Premise
Equipment) user.
9. If this unit malfunctions, the telephone company may disconnect service temporarily. If disconnection is necessary, the
telephone company must attempt to notify the user in advance, if possible. If not, they must notify the user as soon as
they are able.
10. Repair work on this device must be done by Ericsson GE, or an authorized repair station.
DOC REGISTRATION
The Canadian Department of Communications label identifies certified equipment. The certificate means that the equipment
meets certain telecommunications network protective, operational, and safety requirements. The Department does not
guarantee the equipment will operate to a user's satisfaction.
Before installing this equipment, make sure you are permitted to connect it to the facilities of the local telecommunications
company. You must also install the equipment using an acceptable method of connection. In some cases, you many also
extend the company's inside wiring for single line individual service by means of a certified connector assembly (telephone
extension cord). You should be aware, however, that compliance with the above conditions may not prevent degradation of
service in some situations.
Repairs to certified equipment should be made by an authorized Canadian maintenance facility designated by the supplier.
Any repairs or alterations made by a user to this equipment, or equipment malfunctions, may give the telephone
communications company cause to request the user to disconnect the equipment.
For your own protection, make sure that the electrical ground connections of the power utility, telephone lines, and internal
metallic water pipe system, if present, are connected together. This precaution may be particularly important in rural areas.
Do not attempt to make electrical ground connections yourself; contact the appropriate electric inspection authority or
electrician.
CAUTION
GTI Load Number: 10
The load number (LN) assigned to each terminal device denotes the percentage of the maximum allowable load to prevent
overloading, to be connected to the telephone loop used by the device. The termination on a loop may consist of any
combination of devices, subject to the requirement that the total of the load numbers of all the devices not exceed 100.
DOC COMPLIANCE NOTICE
This digital apparatus does not exceed the Class A limits for radio noise emissions for digital apparatus as set out in the
Radio Interference Regulations of the Canadian Department of Communications.
DOC AVIS DE CONFORMATION
Le present appareil numerique n'emet pas de bruits radioelectriques depassant les limites applicables aux appareils
numeriques de la classe A prescrites dans le Reglement sur le brouillage radioelectrique edicte par le ministere des
Communications du Canada.