Hongdian H8951 3G/4G Wi-Fi router - Manual (Page 87)

H8951 3G/4G Router 5 Router config
(2014-07-01) - 71 -
Table 5-26 QoS parameter instruction
Parameter Details Option
Status Enable or disable QoS feature Click the button to select
Basic Setting
Rule Name QoS rule name The max to 12 characters
Only set when adds a new rule
and the follow-up can not be
modified
The rule name can not be
repeated, otherwise the rule will
be covered after the rule is
added in front of the cover
Control
Interface The interface type of QOS, include:

br0：QOS interface is LAN
 modem：QOS interface is modem
Dropdown List
Network The network address that flow into or
out QOS, the limited speed of object Full in destination address and
subnet mask
Manual input
Format1: A.B.C.D/Mask
Port The network interface of QOS Value area: 1-65535
You can not configure the port,
if not the configuration
represents all ports
Rate Transmission rate of the network
address settings Value area：1～65535
Units：Kbps
Ceil Rate In ensuring the basic rate and the spare
bandwidth, the maximum bandwidth of
the network address of the
communication can be obtained with
higher priority will be given priority
redundant bandwidth Value area：1～65535
Units：Kbps
Priority Set the precedence of the rules Value area：[1,30]
Step 4 Single click “save” icon to QOS setting.
QOS is mainly for the average of user priority assigned route or a bandwidth of Internet users. If the router is
connected with two subnets: 192.168.8.1/24 and 192.168.9.1/24, the router QOS can control the rate of these
two subnets; If the router's bandwidth is relatively well-off, the router can be based on two subnets redundant
bandwidth is first priority and high priority redundancy to meet the bandwidth, then meet low priority subnet
redundancy bandwidth.