Hongdian H8951 3G/4G Wi-Fi router - Manual (Page 80)

5 Router config H8951 3G/4G Router
(2014-07-01) - 64 -
Parameter Details Operation
Protocol Supports “TCP”, “UDP”,
“ICMP” or “ALL” Select from Dropdown List
Original Address
Type The destination address of
the IP packet needs to be
converted Dropdown List

interface
 static
Interface (when
the initial address
type select
“interface” ,
needs to be
configured) Indicates the destination
address of IP packets to an
interface of the router Dropdown List
 br0

modem
 eth0
 eth1
Original Address
(when the initial
address type
select “static”,
needs to be
configured) The source address of IP
packet, the source
address needs to be
converted Manual input
Format1：A.B.C.D
Format2: A.B.C.D/Mask
Original port The port of destination
address need to be replaced Value area: 1～65535
Mapping address The new source address
after destination address is
replaced e.g. 192.168.8.1
Mapping port The port of destination
address after is replaced Value area :1～65535
Step 5 Single click “save” icon to finish.
---END
SNAT configuration rule
SNAT is the source address translation, and its role is to translate source address of IP packets
into another address.
Step 1 Log-on WEB GUI of H8951 3G/4G router.
Step 2 Click “Forward > NAT” to open “NAT” tab.
Step 3 NAT Type select “SNAT”, Configuration interface as shown in Figure 5-47.