Hardware installation, 1 option card mounting, Hardware – Yaskawa GPD505 User Manual
Page 4: Installation, Ption, Ounting
2. Hardware Installation
This section describes steps necessary to install the option card and configure the drive for its use. Since
this option is available pre-installed or in kit form, many of these steps may have been completed at the
factory. If already installed, users should still review these steps to become familiar with the procedure.
Refer to Figure 1 for the physical location of switches, LEDs and connectors.
EPROM
DC-DC
CONV
S3
S1
S2
CPU
UART
RXD
TXD
FAULT
Figure 1. Option Card Layout
2.1 Option Card Mounting
CAUTION:
Make sure that the input power to the drive is TURNED OFF and the CHARGE lamp
inside the unit is OFF before installing the option card.
Step 1.
Remove the digital operator, applying pressure to the locking plate on its lower right side, as
illustrated in Figure 2. Lift the operator out by pulling forward.
TM4028
7/12/2001
4