Yaskawa E7 Drive Technical Manual - Manual (Page 28)

Date: 02/25/2010, Rev: 10-02 Page 28 of 34 TM.F7SW.064
Master Run Input
Follower Run Input
Align Input
Master Trig Input
Follower Trig Input
Master Motor Speed
Follower Motor Speed
Align Complete Output
In Alignment Output
Align Trim Rate (P4-02)
Reverse Run - Alignment - Master Before Follower
Master Run Input
Follower Run Input
Align Input
Master Trig Input
Follower Trig Input
Master Motor Speed
Follower Motor Speed
Align Complete Output
In Alignment Output
Align Trim Rate (P4-02)
Reverse Run - Alignment - Follower Before Master
Note: The “Align Input” is edge triggered. It doesn’t matter whether the input is maintained or momentary.