3 receiving, Option package contents, Tools required for installation – Yaskawa SI-EP3 PROFINET Technical Manual User Manual
Page 8: 3receiving

8
YASKAWA ELECTRIC SIEP C730600 69A 1000-Series Option SI-EP3 Technical Manual
3 Receiving
3
Receiving
Please perform the following tasks upon receiving the option:
• Inspect the option for damage. Contact the shipper immediately if the option appears damaged upon receipt.
• Verify receipt of the correct model by checking the model number printed on the name plate of the option package.
• Contact your supplier if you have received the wrong model or the option does not function properly.
Option Package Contents
Table 2 Option Package Contents
Tools Required for Installation
• A Phillips screwdriver (M3 metric/#1, #2 U.S. standard size
) is required to install the option and remove drive front
covers.
• Diagonal cutting pliers. (required for some drive models)
• A small file or medium grit sandpaper. (required for certain drive models)
Note: Tools required to prepare option networking cables for wiring are not listed in this manual.
Description:
Option
Ground
Wire
Screws (M3)
LED Label
Installation Manual
_
Quantity:
1
1
3
1
1
<1> Screw sizes vary by drive capacity. Select a screwdriver appropriate for the drive capacity.
NS
MS
MANUAL
PROFINET_E_conditional.book 8 ページ 2015年2月25日 水曜日 午後5時17分