Yaskawa 1000 Series Drive Option - Profibus-DP Installation - Manual (Page 21)

5 Installation Procedure
YASKAWA ELECTRIC TOBP C730600 42C 1000-Series Option SI-P3 Installation Manual 21
7.
Route the option wiring.
Depending on the drive model, some drives may require routing the wiring through
the side of the front cover to the outside. In these cases, use diagonal cutters to cut
out the perforated openings in the left side of the drive front cover as shown in
Figure 10 -A, and leave no sharp edges to damage wiring.
Route the wiring inside the enclosure as shown in Figure 10 -B for drives that do not
require routing through the front cover. Refer to the Peripheral Devices & Options
section of the drive Technical Manual for more information.
Figure 10
Figure 10 Wire Routing Examples
8.
After connecting the prepared cable for the 9-pin D-sub communication connector
CN5, recheck the option wire routing performed in step 6.
A – Route wiring through the openings
on the left side of the front cover.
<1>
<1> The drive will not meet NEMA Type 1 requirements if wiring is exposed outside the enclosure.
B – Use the open space inside the
drive to route option wiring.
A
B