Yaskawa 1000 Series Drive Option - MECHATROLINK-II Installation - Manual (Page 8)

8 YASKAWA ELECTRIC TOBP C730600 50C YASKAWA 1000-Series Option SI-T3 Installation Manual
2 Product Overview
2 Product Overview
◆
About This Product
MECHATROLINK-II Option (Model: SI-T3) is designed for connecting a unit to a field
network using the MECHATROLINK protocol.
When installing the MECHATROLINK-II Option to a unit, it is possible to do the following
from a MECHATROLINK master device:
• operate the unit
• monitor the operation status of the unit
• change parameter settings
◆
Applicable Models
The option can be used with the unit models in Table 1 .
Table 1 Applicable Models
Note: 1. Make sure that SI-T3’s software version is 6105 and later when installing it to D1000 or R1000.
2. MECHATROLINK-II commands deffer between Intelligent I/O slave devices and MECHATROLINK
Drive slave devices. For details, refer to unit instruction manual.
Unit Series Unit Model Number MECHATROLINK Slave Name SI-T3 Software Version
A1000 CIMR-A††A†††† MECHATROLINK Drive slave ≥ 6100
D1000 CIMR-D††A††††
Intelligent I/O slave ≥ 6105
R1000 CIMR-R††A††††