SMA FLX Series PLA Option - Manual (Page 6)

Illustration 1.2 Scope of Delivery: PLA Option
To install the option:
1. On the inverter, open the cover of the installation
area.
2. Insert the PLA Option into 1 of the 2 option slots;
option slot 1 or option slot 2, see Illustration 1.3.
Fasten with a ‘click’ on both sides of the option.
3. Insert the cable gland into the heat sink.
4. Connect wires from, for example, a remote
control device, see Illustration 1.1.
5. Fasten wires with cable tie.
Illustration 1.3 Communication Board - Open Position
Installation
L00410649-02_2q / Rev. date: 2014-06-20 5
1 1