SMA FLX Series PLA Option - Manual (Page 12)

2.1.3 Configuring Remotely Controlled
Adjustment of Power Factor
To configure the remotely controlled Power Level
Adjustment, choose the ‘Power factor’ submenu.
• Set the ‘Remotely controlled Power Factor’ radio
button.
• Configure the relay states (K1–K6) according to
the requirements of the DNO by entering the
appropriate Power Factor setpoint for each relay
state specified by the DNO.
The inverter runs according to the entered Power Factor
value.
Illustration 2.4 Configuring Power Factor
Setup
L00410649-02_2q / Rev. date: 2014-06-20 11
2 2