Eclipse - Fujitsu Ten CD3100 - Manual (Page 38)

38
Various Settings
How to operate the AUDIO CONTROL
Switching audio control modes
Various audio control modes may be fine-tuned using this procedure.
Modes will switch in the order shown below each time the button is pressed.
BASS
→ MID → TREB → BAL FAD → NON-F*
2
→ LOUD → SVC*
1
→ BASS
*1: Setting cannot be made in FM mode.
*2: NON-F (non-fader) Output is not affected by the settings of the BASS, MID and
TREBLE.
1
Press the [ENTER] button to select the item to be adjusted.
WARNING
Do not adjust the volume or other controls while driving the vehicle. Do so only while parked in a
safe location.
Mode Function
Button operation (Press [SELECT] button)
Upper Lower Right Left
BASS Adjusts bass level.
Emphasizes
low sounds. Softens low
sounds.
- -
MID
(MIDDLE)
Adjusts middle level.
Emphasizes
medium
sounds. Softens
medium
sounds.
- -
TREB
(TREBLE)
Adjusts treble level.
Emphasizes
high sounds. Softens high
sounds.
- -
SVC
Adjusts different volume levels for
each audio mode. When SVC is set,
the volume level can change as
shown in the example setting (See
next page).
Increase the
SVC setting
level. Decrease the
SVC setting
level.
- -
BAL/FAD
(FADER/
BALANCE)
Adjust left/right (BALANCE) and
front/rear (FADER) speaker balance.
Emphasizes
front
speakers. Emphasizes
rear
speakers. Emphasizes
right
speakers.
Emphasizes
left speakers.
NON-F
(NON-FADER
LEVEL)
Adjusts non-fader level (for
connected sub-woofer).
Increase the
sub-woofer
level. Decrease the
sub-woofer
level.
- -
LOUDNESS
The loudness control may be turned
on the emphasize low and high
frequencies at low volume levels.
Loudness compensates for the
apparent weakness of low and high
frequencies at low volume by
boosting the bass and treble levels.
Select ON Select OFF - -