HEIDENHAIN SHB Data Interfaces for HEIDENHAIN - Manual (Page 47)

6 – 48 HEIDENHAIN Service Manual for Data Interfaces
6.2 Machine Parameters for TNC 122/124
6.2.1 Overview
6.2.2 Description of the machine parameters
The following list contains the machine parameters for all software variants.
Since however, several machine parameters are not valid for certain controls or have been
introduced or eliminated as of a certain software version, there are columns with symbols
for differentiation.
Meaning of the symbols
= The parameter applies for all software versions of this control.
04 = The parameter was introduced as of a certain software version (e.g. as of version 04).
I04 = The parameter was eliminated as of a certain software version (e.g. as of version 04)
or replaced by a new parameter.
- = The parameter is not active with this software (control).
Explanation of the columns
TNC 124 = TNC 124 with NC software 246 16* --
Function TNC
122 124
Data transfer rate - 5040