beautypg.com

Control panel, Error messages – Epson Sylus Pro 10600 User Manual

Page 8

background image

EPSON Stylus Pro 10600

8 - EPSON Stylus Pro 10600

9/02

Control Panel

The control panel includes various lights and a display to
indicate the status of the printer:

When your ink or paper runs out or a problem occurs, a
message appears on the display. The lights on the control
panel come on or flash. The following table lists the messages
and includes an explanation and instructions for correcting
the problem.

Display

Error messages

Message

Light

Explanation

Response

INK LOW

Ink Out light(s)
flashing

Ink cartridge(s) are nearly empty
(printing continues).

Replace ink cartridge(s) indicated by Ink Out light(s). See page 10
for instructions.

INK OUT

Ink Out light(s) on

Ink cartridge(s) are empty
(printing stops).

Replace the ink cartridge(s) indicated by Ink Out light(s). See page
10 for instructions.

NO INK CARTRIDGE

Ink Out light(s) on

Ink cartridge(s) not installed.

Install ink cartridges as indicated by the lights. Make sure you
install the correct Photographic Dye, Archival ink, or UltraChrome
ink cartridges. See page 10 for instructions.

WRONG CARTRIDGE

INVALID CARTRIDGE

Ink Out light(s) on

You tried to install the wrong ink
cartridge.

If you are installing ink cartridges for the first time, you must
install the cartridges that came with your printer.

If you are replacing ink cartridges, check the package and product
code. You must use the ink cartridges designed for your printer.
Other cartridges will not work.

FRONT COVER OPEN

Pause light on

Lower cover is open.

Close the lower cover.

INK COVER OPEN

Pause light on

You are replacing the ink
cartridge(s) and the ink
compartment cover is open.

Close the ink compartment cover when you are finished replacing
the ink cartridge(s).

LOAD ROLL PAPER

LOAD SHEET PAPER

Paper Out light on

Paper source setting in printer
software is different from
control panel.

Make sure the right paper is loaded and the paper source setting
is the same on the control panel and printer software.

PAPER JAM

Paper Out light
flashing

Paper has jammed in the printer.

Remove the jammed paper.

PAPER NOT CUT

Paper Out light
flashing

Roll paper was not cut
completely.

Cut the paper manually, then remove the cut paper from the
printer and reload it.

Cut paper did not fall off.

Remove the cut paper from the printer. Reload paper.

PAPER NOT STRAIGHT

Paper Out light
flashing

Paper was fed into the printer at
an angle.

Reload paper, making sure the edges are straight and aligned
with the vertical row of holes at the paper exit.

PAPER OUT

Paper Out light on

No paper is loaded.

Load paper.

Paper ran out.

Remove any printouts or paper remaining in the printer and load
more paper.

If the message appears during a print job, reset the printer by
pressing the Pause button for 3 seconds. Then load paper and
resend the job.