Epson Sylus Pro 10600 - Manual (Page 16)

EPSON Stylus Pro 10600
16 - EPSON Stylus Pro 10600 9/02
8. Insert the new cutter.
9. Push down on the cutter’s side pin while turning the latch
to the left.
10. Close the lower cover. The print head returns to the home
position.
Replacing the Maintenance Tank
When the maintenance tank is nearly full, the printer displays
the following message on the control panel:
MAINTENANCE REQ. 0100
You should call to schedule service at this point. When the
waste ink system is at full capacity, the printer stops and
displays the following message:
SERVICE REQ. 00000100
Approximately every two years of normal usage (25% duty
cycle) or after 20,000 B0-size prints, you should have your
authorized EPSON servicer replace the waste ink system. This
is necessary to prevent damage to the print head and maintain
print quality. Parts and labor for this service are not covered
under the terms of the limited warranty.
You can monitor the status of the waste ink system by printing
the status check sheet (see page 9); a low value (or a value near
Empty) indicates that the pad is nearing the end of its service
life.
Related Documentation
CPD-15012 EPSON Stylus Pro 10600 Printer Guide
CPD-15013 EPSON Stylus Pro 10600 Quick
Reference Guide
CPD-15014 EPSON Stylus Pro 10600 CD-ROM with
electronic Reference Guide
PL-SP10600 Parts Price List