HEIDENHAIN TNC 620 (34056x-04) ISO programming - Manual (Page 381)

Using 3-D touch probes (Touch Probe Function software option) 13.5
13
TNC 620 | User's Manual for DIN/ISO Programming | 5/2013
381
13.5 Using 3-D touch probes (Touch Probe
Function software option)
Overview
The following touch probe cycles are available in the Manual
Operation mode:
HEIDENHAIN only gives warranty for the function of
the probing cycles if HEIDENHAIN touch probes are
used.
The TNC must be specially prepared by the machine
tool builder for the use of a 3-D touch probe. Refer to
your machine manual.
Function Soft key Page
Calibrating the effective length 389
Calibrating the effective radius 390
Measuring a basic rotation using a
line 394
Setting a datum in any axis 396
Setting a corner as datum 397
Setting a circle center as datum 399
Setting the centerline as datum 401
Touch probe system data
management See User’s
Manual for
Cycles
For more information about the touch probe table,
refer to the User’s Manual for Cycle Programming.