HEIDENHAIN TNC 620 (34056x-04) ISO programming - Manual (Page 34)

Contents
34
TNC 620 | User's Manual for DIN/ISO Programming | 5/2013
13 Manual operation and setup.........................................................................................................357
13.1 Switch-on, switch-off........................................................................................................................... 358
Switch-on................................................................................................................................................ 358
Switch-off................................................................................................................................................360
13.2 Moving the machine axes................................................................................................................... 361
Note........................................................................................................................................................ 361
Moving the axis with the machine axis direction buttons..................................................................... 361
Incremental jog positioning....................................................................................................................361
Traverse with electronic handwheels.....................................................................................................362
13.3 Spindle speed S, feed rate F and miscellaneous function M.......................................................... 372
Application.............................................................................................................................................. 372
Entering values.......................................................................................................................................372
Adjusting spindle speed and feed rate.................................................................................................. 373
13.4 Datum setting without a 3-D touch probe........................................................................................ 374
Note........................................................................................................................................................ 374
Preparation..............................................................................................................................................374
Workpiece presetting with axis keys..................................................................................................... 374
Datum management with the preset table........................................................................................... 375
13.5 Using 3-D touch probes (Touch Probe Function software option).................................................. 381
Overview................................................................................................................................................ 381
Functions in touch probe cycles............................................................................................................ 382
Selecting touch probe cycles................................................................................................................. 384
Recording measured values from the touch-probe cycles.....................................................................385
Writing measured values from the touch probe cycles in a datum table.............................................. 386
Writing measured values from the touch probe cycles in the preset table........................................... 387
13.6 Calibrating a 3-D touch trigger probe (software option Touch probe functions)........................... 388
Introduction.............................................................................................................................................388
Calibrating the effective length.............................................................................................................. 389
Calibrating the effective radius and compensating center misalignment.............................................. 390
Displaying calibration values.................................................................................................................. 392