HEIDENHAIN TNC 620 (34056x-04) ISO programming User Manual
Page 18
Contents
18
TNC 620 | User's Manual for DIN/ISO Programming | 5/2013
2
Introduction.......................................................................................................................................65
2.1
The TNC 620........................................................................................................................................... 66
Programming: HEIDENHAIN conversational and ISO formats.................................................................66
Compatibility............................................................................................................................................. 66
2.2
Visual display unit and operating panel..............................................................................................67
Display screen.......................................................................................................................................... 67
Setting the screen layout......................................................................................................................... 68
Control Panel............................................................................................................................................ 68
2.3
Modes of Operation............................................................................................................................... 69
Manual Operation and El. Handwheel..................................................................................................... 69
Positioning with Manual Data Input.........................................................................................................69
Programming............................................................................................................................................ 69
Test Run................................................................................................................................................... 70
Program Run, Full Sequence and Program Run, Single Block................................................................. 70
2.4
Status displays....................................................................................................................................... 71
"General" status display............................................................................................................................ 71
Additional status displays......................................................................................................................... 72
2.5
Accessories: HEIDENHAIN 3-D Touch Probes and Electronic Handwheels.......................................78
3-D touch probes (Touch Probe Function software option)......................................................................78
HR electronic handwheels....................................................................................................................... 79