HEIDENHAIN TNC 620 (340 56x-03) Cycle programming - Manual (Page 97)

HEIDENHAIN TNC 620 97
4.3 RIGID T
A
PPING without a Floa
ting T
a
p Holder NEW (Cy
c
le
207
,
DIN/ISO:
G207)
4.3 RIGID TAPPING without a
Floating Tap Holder NEW
(Cycle 207, DIN/ISO: G207)
Cycle run
The TNC cuts the thread without a floating tap holder in one or more
passes.
1 The TNC positions the tool in the spindle axis at rapid traverse
FMAX to the entered set-up clearance above the workpiece
surface.
2 The tool drills to the total hole depth in one movement.
3 Once the tool has reached the total hole depth, the direction of
spindle rotation is reversed and the tool is retracted to the set-up
clearance at the end of the dwell time. If programmed, the tool
moves to the 2nd set-up clearance at FMAX.
4 The TNC stops the spindle turning at set-up clearance.