HEIDENHAIN TNC 620 (340 56x-03) Cycle programming - Manual (Page 11)

HEIDENHAIN TNC 620 11
New F
u
nctions of Sof
tw
a
re
340 56x
-03
New Functions of Software 340 56x-03
„ The function M101 was introduced (see User’s Manual for
Conversational Programming).
„ Tool tables of the iTNC 530 can now be imported in the TNC 620 and
converted to a valid format (see User’s Manual for Conversational
Programming).
„ The CYCL CALL POS function was introduced (see page 45).
„ Local and nonvolatile QL and QR Q parameters were introduced (see
User's Manual for Conversational Programming).
„ You can now perform a tool usage test before starting the program
(see User's Manual for Conversational Programming).
„ The function M138 for selecting tilting axes was introduced (see
User’s Manual for Conversational Programming).
„ File functions were introduced (see User’s Manual for
Conversational Programming).
„ The "Define coordinate transformations" function was introduced
(see User’s Manual for Conversational Programming).
„ The TCPM function was introduced (see User’s Manual for
Conversational Programming).
Changed Functions of Software
340 56x-03
„ The status display for Q parameters was revised (see User’s Manual
for Conversational Programming).
„ The tool table was expanded by the LAST_USE column (see User’s
Manual for Conversational Programming).
„ The graphic simulation was extended and adapted to the iTNC 530
(see User’s Manual for Conversational Programming).
„ Touch probe cycles can now also be used in the tilted working
plane(see page 280).