HEIDENHAIN TNC 620 (340 56x-03) Cycle programming - Manual (Page 422)

422 Touch Probe Cycles: Automatic Kinematics Measurement
1
8
.3 SA
VE KINEMA
TICS (Cy
c
le 450, DIN/ISO: G450; Option)
18.3 SAVE KINEMATICS (Cycle 450,
DIN/ISO: G450; Option)
Cycle run
With the touch probe cycle 450 you can save the active machine
kinematic configuration or restore a previously saved one. The saved
data can be displayed and deleted. 16 memory spaces in total are
available.
Please note while programming:
Always save the active kinematics configuration before
running a kinematics optimization. Advantage:
„ You can restore the old data if you are not satisfied with
the results or if errors occur during optimization (e.g.
power failure).
Restore mode: The TNC can restore saved data only to a
matching kinematic configuration.
Restore mode: Note that a change in the kinematics
always changes the preset as well. Set the preset again if
necessary.