HEIDENHAIN TNC 620 (340 56x-03) Cycle programming - Manual (Page 416)

416 Touch Probe Cycles: Special Functions
1
7.1 F
undamentals
17.1 Fundamentals
Overview
The TNC provides a cycle for the following special purpose:
When running touch probe cycles, Cycle 8 MIRROR
IMAGE, Cycle 11 SCALING FACTOR and Cycle 26 AXIS-
SPECIFIC SCALING must not be active.
HEIDENHAIN only gives warranty for the function of the
probing cycles if HEIDENHAIN touch probes are used.
The TNC must be specially prepared by the machine tool
builder for the use of a 3-D touch probe.
The touch probe cycles are available only with the Touch
probe function software option (option number #17).
Cycle Soft key Page
3 MEASURING Cycle for defining OEM
cycles Page 417