HEIDENHAIN 530 (340 49x-07) ISO programming - Manual (Page 46)

46
12.1 Functions for Multiple Axis Machining ..... 400
12.2 The PLANE Function: Tilting the Working Plane (Software Option 1) ..... 401
Introduction ..... 401
Define the PLANE function ..... 403
Position display ..... 403
Reset the PLANE function ..... 404
Defining the machining plane with space angles: PLANE SPATIAL ..... 405
Defining the machining plane with projection angles: PROJECTED PLANE ..... 407
Defining the machining plane with Euler angles: EULER PLANE ..... 409
Defining the working plane with two vectors: VECTOR PLANE ..... 411
Defining the machining plane via three points: PLANE POINTS ..... 413
Defining the machining plane with a single, incremental spatial angle: PLANE RELATIVE ..... 415
Tilting the working plane through axis angle: PLANE AXIAL (FCL 3 function) ..... 416
Specifying the positioning behavior of the PLANE function ..... 418
12.3 Inclined-Tool Machining in the Tilted Plane ..... 423
Function ..... 423
Inclined-tool machining via incremental traverse of a rotary axis ..... 423
12.4 Miscellaneous Functions for Rotary Axes ..... 424
Feed rate in mm/min on rotary axes A, B, C: M116 (software option 1) ..... 424
Shorter-path traverse of rotary axes: M126 ..... 425
Reducing display of a rotary axis to a value less than 360°: M94 ..... 426
Automatic compensation of machine geometry when working with tilted axes: M114 (software option 2) ..... 427
Maintaining the position of the tool tip when positioning with tilted axes (TCPM): M128 (software option
2) ..... 428
Exact stop at corners with nontangential transitions: M134 ..... 431
Selecting tilting axes: M138 ..... 431
Compensating the machine’s kinematics configuration for ACTUAL/NOMINAL positions at end of block: M144
(software option 2) ..... 432
12.5 Peripheral milling: 3-D radius compensation with workpiece orientation ..... 433
Function ..... 433
12 Programming: Multiple Axis Machining ..... 399