HEIDENHAIN 530 (340 49x-07) ISO programming - Manual (Page 21)

New F
u
nctions with 340 49x
-07
HEIDENHAIN iTNC 530 21
New Functions with 340 49x-07
„ Improvement of Dynamic Collision Monitoring (DCM):
„ The display of stepped tools has been improved
„ Extension of the functions for multiple axis machining:
„ In manual mode, you can now also travel the axes again when
TCPM and Tilt Machining Plane are active at the same time
„ You can now also change tools when M128/FUNCTION TCPM is active
„ File management: archiving of files in ZIP archives (see "Archive
files" page 137 ff)
„ The nesting depth for program calls has been increased from 6 to 10
(see “Nesting depth” on page 261)
„ There is now a search function based on tool names available in the
tool selection pop-up window (see “Search for tool names in the
selection window” on page 188)
„ Improvements in pallet machining:
„ The new column FIXTURE has been added to the pallet table to be
able to activate fixtures automatically (see "Pallet Operation with
Tool-Oriented Machining" page 442 ff)
„ The new workpiece status SKIP has been added to the pallet table
(see "Setting up the pallet level" page 448 ff)
„ If a tool sequence list is created for a pallet table, the TNC now
also checks that all the NC programs of the pallet table are
available (see “Calling tool management” on page 194)
„ The new host computer operation was introduced (see “Host
computer operation” on page 588)
„ Improvements to the DXF converter:
„ Contours can now also be extracted from .H files (see “Data
transfer from plain-language programs” on page 254)
„ Preselected contours can now also be selected in the tree
structure (see “Selecting and saving a contour” on page 244)
„ A snap function facilitates contour selection
„ Extended status display (see “Basic settings” on page 240)
„ Adjustable background color (see “Basic settings” on page 240)
„ Display can be changed between 2-D and 3-D (see “Basic
settings” on page 240)
„ Improvements to the global program settings (GS):
„ All the form data can now be set and reset under program control
(see “Technical prerequisites” on page 368)
„ Handwheel superimposition value VT can be reset when tool is
changed (see “Virtual axis VT” on page 376)
„ If the Swapping Axes function is active, it is now permitted to
position to machine-based positions on the axes that have not
been swapped