HEIDENHAIN iTNC 530 (340 49x-01) ISO programming - Manual (Page 77)

HEIDENHAIN iTNC 530 77
3.1 Pr
ogr
amming and Ex
ecuting Simple Mac
h
ining Oper
ations
First you pre-position the tool in L blocks (straight-line blocks) to the
hole center coordinates at a setup clearance of 5 mm above the
workpiece surface. Then drill the hole with Cycle 1 PECKING.
Straight-line function G00 (see “Straight line at rapid traverse G00
Straight line with feed rate G01 F. . .” on page 183), Cycle G200
DRILLING (see “DRILLING (Cycle G200)” on page 250).
%$MDI G71
N10 G99 T1 L+0 R+5 Define tool: zero tool, radius 5
N20 T1 G17 S2000 Call tool: tool axis Z
spindle speed 2000 rpm
N30 G00 G40 G90 Z+200 Retract tool (rapid traverse)
N40 X+50 Y+50 M3 Move the tool at rapid traverse to a position above
the hole spindle on
N50 G01 Z+2 F2000 Position tool to 2 mm above hole
N60 G200 DRILLING Define Cycle G200 Drilling
Q200=2 ;SET-UP CLEARANCE Set-up clearance of the tool above the hole
Q201=-20 ;DEPTH Total hole depth (Algebraic sign=working direction)
Q206=250 ;FEED RATE FOR PLNGNG Feed rate for pecking
Q202=10 ;PLUNGING DEPTH Depth of each infeed before retraction
Q210=0 ;DWELL TIME AT TOP Dwell time at top for chip release (in seconds)
Q203=+0 ;SURFACE COORDINATE Workpiece surface coordinate
Q204=50 ;2ND SET-UP CLEARANCE Position after the cycle, with respect to Q203
Q211=0.5 ;DWELL TIME AT DEPTH Dwell time in seconds at the hole bottom
N70 G79 Call Cycle G200 PECKING
N80 G00 G40 Z+200 M2 Retract the tool
N9999999 %$MDI G71 End of program