HEIDENHAIN iTNC 530 (340 49x-01) ISO programming - Manual (Page 329)

HEIDENHAIN iTNC 530 329
8.4 Cy
cles f
o
r Milling P
o
c
k
ets, St
uds and Slots
8 Starting angle Q245 (absolute value): Enter the polar
angle of the starting point.
8 Angular length Q248 (incremental value): Enter the
angular length of the slot.
8 Infeed for finishing Q338 (incremental value):
Infeed per cut. Q338=0: Finishing in one infeed.
8 Feed rate for plunging Q206: Traversing speed of
the tool while moving to depth in mm/min. Effective
only during finishing if infeed for finishing is entered.