HEIDENHAIN TNC 320 (340 55x-04) ISO programming - Manual (Page 443)

HEIDENHAIN TNC 320 443
Handling of error messages:
„ Help for error messages
„ Help for error messages while a
block is being edited
„ Switching the operating mode while
help menu is active
„ Selecting the background operating
mode while help menu is active
„ Identical error messages
„ Acknowledgment of error messages
„ Access to protocol functions
„ Saving service files
„ Call via ERR key
„ Cause and corrective action cannot
be displayed while highlight is on the
block
„ Help menu is closed when the
operating mode is switched
„ Help menu is closed when F12 is
used for switching
„ Are collected in a list
„ Every error message (even if it is
displayed more than once) must be
acknowledged, the Delete all
function is available
„ Log and powerful filter functions
(errors, keystrokes) are available
„ Available. No service file is created
when the system crashes
„ Call via HELP key
„ Pop-up window shows cause and
corrective action
„ Operating mode switchover is not
allowed (key is non-functional)
„ Help menu remains open when F12
is used for switching
„ Are displayed only once
„ Error message to be acknowledged
only once
„ Complete log without filter functions
available
„ Available. A service file is
automatically created when the
system crashes
Find function:
„ List of words recently searched for
„ Show elements of active block
„ Show list of all available NC blocks
„ Not available
„ Not available
„ Not available
„ Available
„ Available
„ Available
Starting the find function with the
up/down arrow keys when highlight is
on a block Works with max. 9999 blocks, can be
set via config datum No limitation regarding program length
Programming graphics:
„ Depiction of the traverse paths of an
individual NC block after the graphic
was deleted by soft key
„ True-to-scale display of grid
„ Editing contour subprograms in SLII
cycles with AUTO DRAW ON
„ Moving the zoom window
„ Not possible; after pressing CLEAR
GRAPHIC soft key, all previously
defined NC blocks are displayed
„ Available
„ If error messages occur, the cursor is
on the CYCL CALL block in the main
program
„ Repeat function not available
„ Available
„ Not available
„ If error messages occur, the cursor is
on the error-causing block in the
contour subprogram
„ Repeat function available
Programming minor axes:
„ Syntax FUNCTION PARAXCOMP: Define
the behavior of the display and the
paths of traverse
„ Syntax FUNCTION PARAXMODE: Define
the assignment of the parallel axes to
be traversed
„ Available
„ Available
„ Not available
„ Not available
Function TNC 320 iTNC 530