HEIDENHAIN TNC 320 (340 55x-04) ISO programming - Manual (Page 389)

HEIDENHAIN TNC 320 389
15.5 Ether
n
et Int
e
rf
ace
Configuring the control's network address
U Connect the TNC (port X26) with a network or a PC.
U In the file manager (PGM MGT), select the Network soft key.
U Press the MOD key. Then enter the keyword NET123
U Press the CONFIGURE NETWORK soft key to enter the network setting
for a specific device (see figure at center right).
U It opens the dialog window for the network configuration
Setting Meaning
HOSTNAME Name under which the control logs onto the
network. If you use a host-name server, you
must enter the “Fully Qualified Hostname”
here. If you do not enter a name here, the
control uses the so-called null authentication.
DHCP DHCP = Dynamic Host Configuration Protocol
In the drop-down menu, set YES. Then the
control automatically draws its network address
(IP address), subnet mask, default router and
any broadcast address from a DHCP server in
the network. The DHCP server identifies the
control by its hostname. Your company network
must be specially prepared for this function.
Contact your network administrator.
IP ADDRESS Network address of the control: In each of the
four adjacent input fields you can enter 3 digits
of the IP address. With the ENT key you can
jump into the next field. Your network specialist
can give you a network address for the control.
SUBNET MASK Serves to distinguish the net and host ID of the
network: Your network specialist assigns the
subnet mask of the control.
BROADCAST The broadcast address of the control is needed
only if it is different from the standard setting.
The standard setting is formed from the net and
host ID, in which all bits are set to 1.
ROUTER Network address of default router: This entry is
required only if your network consists of several
subnetworks interconnected by routers.
The entered network configuration does not become
effective until the control is rebooted. After the network
configuration is concluded with the OK button or soft key,
the control asks for confirmation and reboots.