HEIDENHAIN MSE 1110 - Manual (Page 26)

26
Connecting a network cable (MSE 1114)
MSE modules communicate with a PC through an RJ-45 connection 5 located on the
base module. Use a straight-through cable when connecting to a hub or a crossover cable
when connecting directly to a PC.
To connect a network cable:
X X Verify power is removed from all power supply modules in the module chain
X X With the cable connector locking tab facing up, insert the cable connector into the
RJ-45 connection 5 on the module until the tab locks into place
Connecting an encoder
This product can be used with HEIDENHAIN length gauges, linear encoders and rotary
encoders that provide EnDat signals. The connecting cable must not exceed 100 meters in
length.
To connect an encoder:
X X Verify power is removed from all power supply modules in the module chain
X X Align the encoder cable connector notch with the module encoder connection notch
X X Insert the cable connector into the encoder connection 6 and tighten the cable
connector by turning clockwise until it is snug
5
RJ­45 connector
6
Encoder connector