HEIDENHAIN MSE 1110 - Manual (Page 22)

22
Mounting a module
To mount a module:
X X Verify power is removed from all power supply modules in the module chain
X X Align the bottom edge of the DIN rail with the bottom channel 12 of the module
X X Gently apply upward pressure, depressing the DIN rail spring 11 and inserting the DIN
rail into the bottom channel 12 of the module
X X While maintaining upward pressure, rotate the top of the module towards the DIN rail
until the top channel 10 of the module is aligned above the DIN rail
X X Gently release the upward pressure, locking the module onto the DIN rail
Connecting modules
Notice
This product contains components that can be damaged by electrostatic
discharge (ESD) . Observe precautions for handling ESD sensitive devices and
never touch connector pins unless properly grounded.
To connect modules:
X X Verify power is removed from all power supply modules in the module chain
X X Slide the right module to the left until the lock tab 3 of the left module engages with
the lock tab receiver 8 of the right module
Mounting a module
Connecting modules
Observe ESD handling precautions