HEIDENHAIN ND 261 v.2 - Manual (Page 3)

Sorting and Tolerance Check Mode
In this mode, the display value is compared with an upper and a lower limit value.
Status indicators and the trigger signal outputs at the D-sub EXT connection (see
that section) indicate whether the display value is less than the lower limit, greater
than the upper limit, or between the two limit values.
Indicator Meaning
= Measured value is between the limit values
< Measured value is less than the lower limit value
> Measured value is greater than the upper limit value
Operating parameters for the sorting mode:
•
P17: Sorting on/off
• P18, P19: Limit values