HEIDENHAIN ND 281 B v.1 - Manual (Page 21)

21
Linear/Angular Measuring Modes
Linear/Angular Measuring Modes
You can select the linear measuring mode or angular
measuring mode by entering the code number 415263:
➤ Select the user parameter P00 CODE
(see “Operating Parameters“).
➤ Enter the code number 415263.
➤ Confirm your entry with ENT.
➤ With the “.” or “–” key, select the ND LENGTH or
ND ANGLE mode, respectively.
➤ Confirm your selection with ENT.
➤ The display unit resets itself.
➤ For further procedure, see “Switch-on, Traversing the
Reference Marks.”